Clonex MIST 750ml

Instructions for use:

• Choose a healthy plant with strong growing tips. If possible the growing tips can be sprayed with Clonex Mist once or twice in the week before cuttings are taken.
• Use a sharp clean blade, such as a scalpel, to make a diagonal cut in the stem - just below a leaf node. Use sharp scissors to trim off some of the larger leaves, leaving two or three on the cutting. 
• If Clonex Rooting Gel is available then dip the cutting straight into the gel.
• Immediately insert cutting into the growing media (rockwool, Jiffy, etc.), which should be moistened before use.
• Spray the new cuttings with Clonex Mist and place in a propagator. The lid should be down and the vents closed.
• After 2-3 days spray the cuttings with Clonex Mist again and open the vents slightly.

Check the new roots after a few days – continue mist until the plant is established following potting up. If planting in soil, place soil carefully around the roots to avoid damaging them

TOP TIP: Repeat this misting every 2-3 days or when cuttings look dry. Open vents wider everyday. A slight condensation inside the propagator indicates adequate humidity.